Radio, Electronics and Computing Projects
by Hans Summers
I make no claims for technical accuracy, good design, or necessarily even originality for the contents of these pages. Rather, I am a simple enthusiast attempting to convey my love and enjoyment of radio, electronics, and computing and perhaps to inspire YOU to build something too. The following pages document projects that I have built over a period of 30 years. Wherever applicable I have named sources and references. In each project I have attempted to provide as much information as time and resources allow, but no responsibility can be accepted for inaccuracies or omissions. Likewise, where some of the projects use mains or high voltages, no responsibility can be accepted for death or injury sustained if you attempt to replicate these projects. BE CAREFUL! If you have any comments or suggestions, please email me.
KÖNNEN SIE GATE.IO OHNE KYC VERWENDEN? |
|
|
OCXO and synthesiser design |
 |
 |
 |
|
Written by Hans Summers
|
|
Monday, 01 September 2014 10:30 |
 |
This page documents the design and development of an OCXO and Synthesiser module. There were several motivations for developing this module, partly as a replacement for the popular AD9850 DDS module, available inexpensively on eBay and elsewhere. |
|
|
Last Updated on Wednesday, 20 May 2015 09:09 |
|
Read more...
|
|
Written by Hans Summers
|
|
Wednesday, 21 January 2015 05:09 |
 |
It's really simple to make a QRP power meter measuring RF output powers from a few mW up to half a watt. This simple project described here is half an hour's work and all components are from the junk box. I used an old "VU" meter from an old piece of consumer equipment, probably a 70's Hi Fi or something similar, long-since forgotten. |
|
|
Last Updated on Wednesday, 20 May 2015 09:04 |
|
Read more...
|
|
Written by Hans Summers
|
|
Wednesday, 10 September 2014 03:26 |
 |
The Weaver method (also called 3rd method) of Single Sideband reception is a little-used technique in HF receivers (except perhaps in Software Defined Radios architectures). This article is an introduction, some practical experiments with a 10m Weaver method receiver, and a collection of information on the subject. |
|
|
Last Updated on Wednesday, 18 November 2015 05:12 |
|
Read more...
|
|
|
Written by Hans Summers
|
|
Thursday, 04 June 2015 03:03 |
 |
Here's a simple and easy single-chip 10.000000000MHz GPS-disciplined frequency reference, based on a small 14-pin AVR microcontroller ATtiny24. This implements a kind of software "Huff Puff" method stabilisation. It uses an old junkbox 10MHz OCXO. The final accuracy is about 0.5 parts per billion (ppb). |
|
|
Last Updated on Monday, 10 October 2016 09:48 |
|
Read more...
|
|
Written by Hans Summers
|
|
Saturday, 03 December 2011 13:35 |
 |
This is the story of my quest to build an all-tube VFO for 26.0 to 26.5MHz, for use in a 21MHz SSB/CW superhet transceiver with 5.0688MHz intermediate frequency (IF). Construction efforts below were assisted by advice and commentary by G4OEP, K3IMW, K7HKL and VK6JY. |
|
|
Last Updated on Wednesday, 20 May 2015 09:13 |
|
Read more...
|
|
Written by Hans Summers
|
|
Monday, 01 June 2015 03:49 |
|
|
|
Last Updated on Sunday, 26 June 2016 09:47 |
|
gate io status
|
|
|
